GoFit - Stability ball

The GoFit Stability Ball offers a challenging yet enjoyable method to stretch, tone, and tighten your physique. Its unique round, unstable surface distinguishes it from training on a stable, flat surface. This design not only engages primary muscle groups but also activates smaller stabilizing muscles crucial for balance, alignment, and posture. This total body workout is highly efficient, allowing for quicker results.

Ball Height Recommendations:
• 55cm (red) - recommended for persons 5' to 5'5"
• 65cm (white) - recommended for persons 5'5" to 6'
• 75cm (blue) - recommended for persons 6' and over

The ball is made of 100% PVC and is 1000lbs static weight-rated. Please note: This ball is not intended for use as a chair.

Included with your purchase:
• Stability Ball
• Training Poster with Inflation Instructions
• Foot Pump
• Ball Plugs and Ball Plug Remover
• Bicycle Pump Adapter
• Measuring Tape

Product Code: GF-55BALL, GF-65BALL, GF-75BALL

Sizing of the ball:
• 55cm—69 inches in circumference or 22 inch diameter
• 65cm—81 inches in circumference or 25.5 inch diameter
• 75cm—93 inches in circumference or 29.6 inch diameter

Size of ball for height of person:
• 55cm is recommended for persons 5’ to 5’5” tall
• 65cm is recommended for persons 5’5” to 6’
• 75cm is recommended for persons 6’ and over

How often should you check your exercise equipment?
GoFit equipment should always be checked thoroughly before each and every use to assure there are no nicks, tears, holes or other damage to the item. Using damaged items could lead to severe injury. If any sign of damage or wear is present, immediately discontinue use of the item and contact GoFit Customer Service for assistance.

Maintenance and Care:
• Clean your exercise ball using a soft cloth with mild soap and warm water. Be sure to remove all residue before use.
• Do not use abrasive or chemical cleaners.
• Keep the Stability Ball out of direct sunlight. The ball should not be placed anywhere where they would be exposed to extreme high or low temperatures or heat sources.
• The life span of the ball will depend on the amount of usage and proper care.

Repairing the ball?
We do not have repair kits for holes in the ball. We do not suggest the repair of any ball as it would hurt the integrity of the ball and potentially make it unsafe.

How to inflate the ball:
Assemble included Foot Pump and follow instructions below.
• Remove the plug from the ball (if applicable)
• Place the foot pump on the floor
• Place the white tip into the air hole in the ball and hold it in place
• Step on the foot pump to deflate it then – let off to allow it to inflate.
• Continue this motion until the ball is ½ full- Put the white ball plug in the air hole.
• Let it sit overnight (this will make it easier to inflate the ball to the suggested size)
• Remove the white ball plug and continue to fill the ball to the suggested size.
• When it is the proper size – insert the white ball plug into the air hole.

Removing the plug?
The ball plug should only be removed with ball plug remover tool that is included to avoid damage to the ball.

What is the ball made of?
The ball is made of non-phthalate PVC.

Ball smells:
The ball does smell some because of the product material. It has been produced and immediately bagged and packed. There will always be some smell of rubber/vinyl but it should lessen over time.

Suggestions to the customer:
• Leave the ball- either inflated or un-inflated (but unfolded) in a protected outdoor space to allow the odor to disperse.
• If the odor does not disperse within 2-3 days- they should contact us for a replacement.

GoFit Product Warranty:
This Limited Warranty applies to physical goods purchased from GoFit, LLC. The Limited Warranty covers any defects in material or workmanship under normal and expected personal use during the warranty period. All GoFit products are warranted for 90 days from purchase.

The Limited Warranty does not cover any problem that has arisen from:
• Use outside of a home environment or personal use. Please note: This ball is not intended for use as a chair.
• Damage from use of the product in a manner not directed.
• Damage from neglect or abuse
• Damage in shipping (unless shipped direct from GoFit Store)
• Any and all other situations that were not related to defect in manufacture.

To obtain warranty service, original owner of the product must contact GoFit Customer Service directly, for review of the problem and resolution appropriate to each customers’ issue.

Q: How do I choose the correct size GoFit Stability Ball for my height?
A: The 55cm ball is for persons 5' to 5'5" tall, the 65cm for 5'5" to 6', and the 75cm for persons 6' and over.

Q: What items are included with the GoFit Stability Ball?
A: It includes the stability ball, a training poster with inflation instructions, a foot pump, ball plugs and remover, a bicycle pump adapter, and a measuring tape.

Q: What is the GoFit Stability Ball made of and how should it be cared for?
A: The ball is made of non-phthalate PVC. Clean with a soft cloth, mild soap, and warm water. Keep out of direct sunlight and extreme temperatures.

Q: What is the recommended process for inflating the GoFit Stability Ball?
A: Inflate the ball halfway, insert the plug, and let it sit overnight. Then, remove the plug and continue filling to the suggested size before re-inserting the plug.

Q: What is the warranty period for the GoFit Stability Ball and what does it cover?
A: All GoFit products are warranted for 90 days from purchase, covering defects in material or workmanship under normal personal use.

All purchases accumulate points which be can used to redeem for discounts on all items in our rewards collection. Enroll or view your current rewards balance here.

• Earn 40 points for every $1 spent equaling 5% cash back